Open The hood
#11
tried it, the wire is broken somewhere along the line.... so it wouldnt work
#12
Then you will have to resort to what Rich above said in post #7....as quoted from the thread he posted:
"If the cable is broken, you reach in behind the grille with a small hooked tool and find the cable going to the latch, hook the cable and pull it out 'this will take quite a bit of force' so you can grab it, you then remove the plastic housing and grab the steel cable with a pliers or other tool and from the latch side- pull hard to release the latch. you should then will have to replace the cable later. Also lube the latch."
"If the cable is broken, you reach in behind the grille with a small hooked tool and find the cable going to the latch, hook the cable and pull it out 'this will take quite a bit of force' so you can grab it, you then remove the plastic housing and grab the steel cable with a pliers or other tool and from the latch side- pull hard to release the latch. you should then will have to replace the cable later. Also lube the latch."
Thread
Thread Starter
Forum
Replies
Last Post
chris015
The Lounge
6
02-14-2012 10:20 AM
sprbld417
1st Generation S-series (1983-1994) Tech
4
04-25-2011 07:28 PM